Heller Acrylic Color - 073 Wine Red Matt 12ml

Product detailed description

Modeling acrylic paint intended for painting or airbrushing. The paint can be diluted with water.

Volume: 12 ml

Note: The color shade presented on the monitor or in printed form may be slightly different from the real one.

Modeling water-dilutable acrylic paint designed for painting or spraying on plastic, metal, wood, ceramics, textiles, or any other suitable surface. Non-flammable base, dries quickly - after approx. 1 hour, the surface can be repainted, fully dries within 2-3 hours.

Not suitable for children under 8 years old. Children's work with paint must always be supervised by an adult. In case of contact with eyes and mucous membranes, rinse with clean water and seek medical attention. In case of ingestion, do not induce vomiting, seek medical help immediately. Do not drink or eat the contents of the container, do not rub it on your skin.

H phrases: H317 May cause an allergic skin reaction. R phrases: none. Symbols: 

Good advice: These water-based paints are best applied to a slightly rough, absorbent surface. When applied to bare plastic or metal, there may be a problem with poor adhesion of the paint at the beginning. Therefore, it is best to prepare the surface of the model, for example, by spraying it with some primer in the form of a spray (e.g. Tamiya Surafcer). For smaller surfaces, we recommend using an airbrush base paint (e.g. Vallejo Surface Primer). The subsequent work with the surface paint is much more convenient and the result is a uniform surface.

Mix the paint well before use. Apply to a well degreased, dry and clean surface. After opening, use as soon as possible, the paint dries due to exposure to air. Always wipe the top of the container dry, do not let the paint residue dry even on the edge. This will extend the shelf life of the paint after resealing.

Dilution: Use plain clean water or distilled water if your tap water is too "hard".

Painting: For painting, it is advisable to leave the paint in a thicker form, diluting it only with a small amount of water. When painting non-absorbent materials (plastic, metal, glass,...) it is usually recommended to prepare the surface with a primer and usually one layer of paint is enough for good coverage. When painting absorbent surfaces (for example, wood), it is not necessary to use a primer, it is enough to apply the first layer of thicker paint and after it has dried thoroughly, cover it with a second thin layer of paint.

Spraying: For spraying, the paint is usually diluted in a ratio of 1 part of water to 1 part of paint, but you can add more water, depending on the type of airbrush and other spraying parameters.

Drying time: Against the touch, the paint literally dries "before your eyes" within a few minutes. Drying can be accelerated by using a hair dryer. Complete drying takes approximately 2 hours, depending on the thickness of the layer. For further painting/spraying with a new layer, just wait a few minutes for the original layer to dry.

Cleaning: Wash immediately with water after using the device. While the paint is fresh, it can be completely washed off without leaving any traces. To clean the brush or airbrush, we recommend using a cleaner for acrylic paints (e.g. Revell Airbrush Email Clean 500 ml)