RC Colour Spray Paint - 52 Blue 150ml

Product detailed description

Modeling spray paint intended for RC models of airplanes or ships.

RC Colors are adapted to the shades of Oracover© - Solarfilm cover films and can also be used for other brands of polyester cover films as well on epoxy surfaces. Not suitable for polystyrene! They are quick-drying and resistant to oils and fuels, so they can also be safely used on RC models with a combustion engine. Apply the paint by holding the well-shaken spray in a vertical position at a distance of approx. 20-30 cm.

Volume: 150ml

Note: The color shade presented on the monitor or in the printed form may be slightly different from the actual one.

Not suitable for children. Children's work with paint must always be supervised by an adult. Combustible, dangerous fumes, thoroughly ventilate the room during work. Do not use open flames and sources of sparks. Do not store near heat sources. Do not eat, drink or smoke while working. In case of contact with eyes and mucous membranes, rinse with clean water and seek medical attention. In case of breathing problems, provide fresh air, ventilate. In case of ingestion, do not induce vomiting, seek medical help immediately. Do not drink or eat the contents of the container, do not rub it on your skin.
H phrases: H222 - Extremely flammable aerosol. H280 - Contains gas under pressure; may explode when heated. H317 - May cause an allergic skin reaction. H319 - Causes serious eye irritation. H336 - May cause drowsiness or dizziness. P phrases: P102 - Keep out of the reach of children. P210 - Keep away from heat/sparks/open flames/hot surfaces. Don't smoke. P211 - Do not spray on an open flame or other ignition source. P280 - Wear protective gloves/protective clothing/safety glasses/face protection.P305 + 351 + 338 - IF IN EYES: Rinse cautiously with water for several minutes. If you wear contact lenses, remove them if possible. Continue rinsing.P332 + 317 - If skin irritation occurs: Get medical attention.P410 + 412 - Protect from sunlight. Do not expose to temperatures above 50°C/122°F. Symbols: see below.

Before use, mix the paint well by shaking the container for at least 1 minute.

For the best results:

• Before spraying, remove all dust and dirt from the surface. Sand the area to be painted with 1000 grit sandpaper. Before painting, treat wooden surfaces with primer.
• Before use, shake the can well for approx. 2 minutes to mix the color perfectly, you must hear the mixing ball.
• Before spraying, mask all unnecessary areas with masking tape or masking products. Spray the paint from a distance of approx. 20-30 cm. Paint the light shades first, then the darker ones. Always make sure the surface is clean, dust free and dry. Apply the paint in thin layers, never spray one thick layer, which can create streaks and degrade the surface.

Drying time: The paint dries to the touch within 20-30 minutes, but it takes at least 4 hours to fully dry, depending on the thickness of the layer. It is recommended to wait at least 12-24 hours before spraying with a new layer.

Cleaning the nozzle: After spraying, turn the container upside down and briefly press the valve. Wipe the remains of the paint from the nozzle with a dry cloth, or soaked in cleaner for spray guns, e.g. Tamiya Airbrush Cleaner or another brand.