Mr Hobby - Gunze Mr. Top Coat Gloss Spray (86 ml)

Product detailed description

Glossy, colorless topcoat for treating the surface of the plastic model after sealing and coloring.

Volume: 86 ml

Not suitable for children. Children's work with varnish must always be supervised by an adult. Combustible, dangerous fumes, thoroughly ventilate the room during work. Do not use open flames and sources of sparks. Do not store near heat sources. Do not eat, drink or smoke while working. In case of contact with eyes and mucous membranes, rinse with clean water and seek medical attention. In case of breathing problems, provide fresh air, ventilate. In case of ingestion, do not induce vomiting, seek medical help immediately. Do not drink or eat the contents of the container, do not rub it on your skin.
H phrases: H222 - Extremely flammable aerosol. H280 - Contains gas under pressure: may explode if heated. P-phrases: P101 - If medical advice is needed, have product container or label at hand. P102 - Keep out of reach of children. P103 - Read label before use. P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P251 - Pressurized container – Do not pierce or burn, even after use. P260 - Do not breathe dust/fume/gas/mist/vapours/spray. P271 - Use only outdoors or in a well-ventilated area. P410 + 412 - Protect from sunlight. Do not expose to temperatures exceeding 50 ºC/122 ºF. P501 - Dispose of contents/container in accordance with national regulations. Symbols: see below.

Before use, mix the paint well by shaking the container, at least 1 minute is recommended.

Spraying: Apply to a well degreased, dry and clean surface in an even thin layer from a distance of 20-40 cm. It is better to gradually apply 2-3 thin layers than one thick one.

Drying time: The varnish dries to the touch within 20-30 minutes, but complete drying takes at least 4 hours, depending on the thickness of the layer. It is recommended to wait at least 16-24 hours before spraying with a new layer.

Cleaning the nozzle: After spraying, turn the container upside down and briefly press the valve. Wipe the remains of the varnish from the nozzle with a dry cloth, or one soaked in airbrush cleaner, e.g. Tamiya Airbrush Cleaner or another brand.