Revell ENAMEL Color - 01 Clear Gloss 14ml

Product detailed description

Glossy modeling synthetic varnish designed for painting or spraying on plastic, metal, wood, ceramics, textiles, or any other suitable surface.

Not suitable for children. Children's work with paint must always be supervised by an adult. Combustible, dangerous fumes, thoroughly ventilate the room during work. Do not use open flames and sources of sparks. Do not store near heat sources. Do not eat, drink or smoke while working. In case of contact with eyes and mucous membranes, rinse with clean water and seek medical attention. In case of breathing problems, provide fresh air, ventilate. In case of ingestion, do not induce vomiting, seek medical help immediately. Do not drink or eat the contents of the container, do not rub it on your skin.
H phrases: H226 Flammable liquid and vapour. H336 May cause drowsiness or dizziness. P-phrases: P101 If medical attention is needed, have the product container or label available. P102 Keep out of reach of children. P103 Read label before use. P210 Keep away from heat/sparks/open flames/hot surfaces. Don't smoke. P280 Wear protective gloves/protective clothing/safety glasses/face protection. P240 Ground/secure container and filling equipment. P303+P361+P353 IF ON SKIN (or hair): Remove/take off all contaminated clothing. Rinse skin immediately with water/shower. P405 Keep locked up. P501 Dispose of contents/container in accordance with local/regional/national/international regulations. Symbols: see below.

Mix the varnish well before use.Apply to a dry and clean surface. After work, always close the container tightly, the varnish dries due to the access of air. Always wipe the top of the container dry, do not let the varnish residue dry even on the edge. This will extend the shelf life of the paint after resealing.

Thinning: Use only original Revell Color mix thinner (39612). Deterioration may occur when using a different diluent.

Painting: For painting, it is advisable to leave the lacquer in a thicker form, dilute it with a small amount of water/Revell Color mix thinner.

Spraying: For spraying, the varnish must be diluted sufficiently. It is usually necessary to test the dilution ratio individually according to the type of spray gun. It can range from 1:1 to 1:3 (varnish: thinner), but if necessary, you can additionally dilute it with a thinner (or a small amount of water), even more.

Drying time: The varnish dries to the touch within 20 minutes, but it takes at least 4 hours to fully dry, depending on the thickness of the layer. It is recommended to wait at least 12 hours for the next coating/spraying with a new layer.

Cleaning: To clean the brush, we recommend the original Revell Painta Clean (39614). To clean the spray gun, we recommend Revell Airbrush Email Clean 500 ml (39005).