Tamiya lexan spray paint - PS-28 Flourescent Green Polycarbonate 100ml

Product detailed description

Tamiya PS are specially developed spray paints for finishing clear polycarbonate RC model bodies. The body is sprayed from the inside so that the can is about 30 cm from the surface. These paints are resistant to oils and fuels, so they can be safely used on RC models with internal combustion engines.

Volume: 100ml

Note: The color shade presented on the monitor or in printed form may be slightly different from the real one.

Modeling paint intended for coloring lexan (polycarbonate).

Not suitable for children. Children's work with paint must always be supervised by an adult. Flammable, dangerous fumes, thoroughly ventilate the room during work. Do not use open flames and sources of sparks. Do not store near heat sources. Do not eat, drink or smoke while working. In case of contact with eyes and mucous membranes, rinse with clean water and seek medical attention. In case of breathing problems, provide fresh air, ventilate. In case of ingestion, do not induce vomiting, seek medical help immediately. Do not drink or eat the contents of the container, do not rub it on your skin.
H phrases: H222 - Extremely flammable aerosol. H229 - Container under pressure: May burst when heated. H318 - Causes serious eye damage.  H332 - Harmful if inhaled. H336 - May cause drowsiness or dizziness.  EUH 066 - Repeated exposure may cause skin dryness or cracking.  P phrases: P102 - Keep out of the reach of children. P210 - Keep away from heat/sparks/open flames/hot surfaces. Don't smoke. P211 - Do not spray on an open flame or other ignition source. P280 - Wear protective gloves/protective clothing/safety glasses/face protection. P405 - Keep locked up. P410 + P412 Protect from sunlight.  Do not expose to temperatures above 50°C/122°F. P501 - Dispose of contents/container by... Contains Vinyl Acetate; Isobutanol; 4-Methylpentan-2-one and Butylglycol.  Symbols: see below.

Before use, mix the paint well by shaking the container, at least 1 minute is recommended.

Painting a Lexan body: First of all, be aware that lexan bodies are usually sprayed from the inside (so the paint doesn't rub off when bumped). That is why, especially in the case of multi-colored body modification, it is necessary to think very well in advance about the spraying process. First, very thoroughly degrease the inner surface of the body using Tamiya Polycarbonate Body Cleaner (87118) or kitchen cleaning detergent. Then cover the windows with masking tape/foil or liquid mask. Then mask all body parts that are to be a different color than the first visible shade (for multi-colored bodies). Apply the paint in an even thin layer from a distance of 20-30 cm. It is better to gradually apply 2-3 thin layers than one thick one. After spraying the first thin layer, look over the body against the light to see if the paint covers everything. Spray the translucent areas again, but only after the first layer has dried. Remove the protective mask before applying the next color. To highlight the body color, it is good to spray a thin layer of white, black, or silver paint at the very end (depending on whether the body color is light, dark, or metallic). This will highlight the body color itself and make it look nicer.

Drying time: The paint dries to the touch within 20-30 minutes, but it takes at least 4 hours to fully dry, depending on the thickness of the layer. It is recommended to wait at least 12-24 hours before spraying with a new layer.

Cleaning the nozzle: After spraying, turn the container upside down and briefly press the valve. Wipe the remains of the paint from the nozzle with a dry cloth, or soaked in cleaner for airbrushes, e.g. Tamiya Airbrush Cleaner or another brand.